With the revised version 2020 of their program for heat pump systems, GeoT*SOL, Valentin Software is once again expanding the area of application of the design tool. A new system variant with a bivalent heat pump system consisting of a hydraulic switch and separate buffer tanks for domestic hot water and heating represent an application that is often used in practice. By using a hydraulic switch, the heat pump loads the heating buffer tank and supports the heating for domestic hot water. Reheating via a conventional heat generator is mainly responsible for heating domestic hot water, but also supports heating at low temperatures. For this system, as for all previously available system interconnections, the characteristic values can also be calculated according to the latest VDI guideline 4650. The extensive database has been updated and, with over 3,900 products, contains all heat pumps eligible for support according to BAFA (as of January 2020).
The most important plants can be mapped
As before, air heat pumps and those with geothermal probes that extract their heat through drilling down to a depth of 100 meters can be calculated and simulated. And it is also possible to design heat pump systems that use groundwater or geothermal collectors laid horizontally in the ground as a heat source. In addition to the heat performance factor, the program calculates the annual energy yields and makes statements on cost-effectiveness and emission reduction compared to conventional systems. The software presents all of the results graphically. These include the annual course of the relevant temperatures, the useful heat and the electrical energy as well as the weekly heat performance factor.
Systems can be variably parameterized
When designing a system, the user can choose between various predefined system configurations that have proven themselves in practice. In addition to the monovalent and monoenergetic systems with heat pump and solar thermal system, new bivalent systems with additional heat generators have been added. Thus, it is possible to simulate existing systems with condensing boilers, compact heating systems and other boilers, with the addition of a heat pump. New plants with a conventional heat generator as backup can now also be simulated and optimized. In addition to heat pumps, all heat generators can of course also be selected from a comprehensive and up-to-date database of nearly 1,600 products. For the simulation, the operating mode can be selected and parameterized from a large number of possible combinations of monovalent, monoenergetic and bivalent systems with parallel, partially parallel or alternative operation.
