Severe leading-edge erosion has long sat in an awkward place in blade maintenance: too deep for coating-type repairs, too common to treat as an exception and traditionally addressed by rope access teams. Aerones says it has now carried out the first robotic repairs of Category 4 leading-edge erosion on operating wind farms, following engineering trials at its own test site.
Severe leading-edge erosion is one of the most common problems in operating wind fleets and one of the hardest to plan around. Once erosion breaks through the protection layer and filler and reaches the glass-fibre laminate, the job changes character. It is no longer a coating job. It becomes a structural rebuild on a suspended blade, traditionally carried out by rope access technicians, governed by weather and slow cure chemistry, with quality that varies from technician to technician.
For operators, that has meant a familiar dilemma: repair slowly, defer and accept the production loss or start thinking about replacement earlier than the blade deserves.
Manual repair has meant technicians on ropes at every blade, sanding eroded areas by hand, rebuilding the laminate patch by patch and reshaping the profile with filler and a spatula by eye. It is dangerous work, and the result depends on the person doing it. Uneven edges change the aerofoil, cost efficiency and give erosion a place to start again.
Robotic repair is already used for lighter erosion: Aerones robots prepare the surface, restore the profile and apply leading-edge protection in a planned, documented sequence operated from the ground. This year the company extended its process to severe erosion. Aerones reports that the method is now in use on operating turbines, with a current operational target of one blade per day.