A boat landing may be a relatively small part of an offshore wind turbine, but it takes a considerable amount of punishment.
Every crew transfer vessel (CTV) approach brings repeated mechanical contact in an environment already exposed to seawater, salt, changing tides and UV. Buoyant Works believes looking at this simply as a coating problem misses an important part of what is happening: wear and corrosion are working together.
Why boat landings are vulnerable
Boat landings face several stresses simultaneously:
During personnel transfer, a CTV maintains contact with the structure and transfers loads through its fendering system.
Over thousands of approaches, this can progressively abrade protective coatings, thin paint films and eventually expose the underlying steel.
Once bare steel is exposed to oxygen-rich seawater, corrosion begins. Further vessel contact can remove the resulting corrosion products and expose fresh steel again, continuing the cycle.
Preventing damage rather than repeatedly repairing it
Offshore coating repair can be difficult and expensive. Effective restoration requires suitable surface preparation and environmental conditions, while access depends on weather, vessels and specialist personnel.
Buoyant Works believes that reducing the occurrence of damage may therefore provide greater value than concentrating only on making repairs more efficient.
One approach is to introduce sacrificial protective interfaces over the designated vessel contact areas.
Rather than requiring the coating to provide both corrosion protection and resistance to repeated mechanical contact, the two functions are separated. The sacrificial element absorbs wear while the underlying coating remains protected.
New-build and retrofit applications
Protective interfaces can be incorporated into new structures after coating during fabrication, allowing vulnerable areas to be protected from the beginning of operation.
The same principle can also be applied to existing assets where repeated CTV contact has already produced coating degradation.
Retrofittable protection could be particularly relevant as operators consider life extension and seek to reduce future deterioration without replacing otherwise serviceable secondary steelwork.
Considering material sustainability
Material selection is another part of the discussion.
Buoyant Works says its protective interface materials can use 100% recycled feedstock with approximately 50% bio-based content.
Extending the service life of secondary structures could reduce replacement steel requirements, while fewer offshore repair campaigns may also reduce associated maintenance logistics.
However, the article stresses that sustainability should not take priority over technical suitability.
Thinking about whole-life performance
Boat landings may represent a relatively small part of an offshore turbine, but repeated wear can create disproportionate maintenance requirements.
Recognising the problem as tribo-corrosion changes the protection strategy. Instead of expecting coatings alone to withstand both the marine environment and repeated mechanical contact, layered protection can separate corrosion resistance from wear resistance.
Looking at boat landing deterioration as tribo-corrosion changes the question from how to repair the coating to how to stop repeated contact damaging it in the first place.
Explore the complete industrial insight in PES Wind: https://pes.eu.com/exclusive-articles/rethinking-protection-strategies-for-boat-landings